Welder jobs in Utica, NY

Description

The Welder position is quite varied with regard to the scope of work performed. Workers who are designated as Welder may also be tasked with other general work tasks not specifically covered under the Welder job description. Tasks may include the following but are not limited to; as job duties may change throughout day depending on the workload.

Work Hours: 8 hours shifts, (2- 15 minute breaks, 30 minute lunch)

Requirements

Essential Minimum Duties and Responsibilities:

· Comply with all Feldmeier safety and Company policies and Occupational Health and Safety Regulations. 

· Ability to TIG weld, spot weld and MIG weld stainless steel.

· Interpret blueprints, drawings, and measurements to plan layouts. 

· Layout component locations per instructions. 

· Prepare work surface via cutting and finishing.

· Weld small and large components in flat, vertical, and overhead positions via appropriate welding technique.

· Set up and operate equipment for assigned jobs. 

· Complete housekeeping duties in assigned area or as requested by management. 

· Complete all required paperwork and properly log time into the MES system, logging on and off.

· Wear proper PPE.

· Perform other duties as assigned.

Physical Requirements:

· Ability to stand and/or walk for up to 8 hours per day.

· Continual use of hands; pushing, pulling, grasp, hold, move, and maintain 20 pounds constantly with full range of motion, including above head, below feet and side to side. 

· Occasional lifting, carrying, and maneuvering up to 50 pounds. 

· Ability to climb ladders, stairs, and platforms for elevated work.

· Walking, bending, squatting, kneeling, balancing, stooping, lie down inside or under vessel and twisting while performing required job tasks.